Furnace Repair Done Right Before the Cold Hits

Common Furnace Failures We See

The East Mountains, Sandia Park, and the higher-altitude communities push furnaces harder than people realize — long heat cycles, cold-soaked starts, and short shoulder seasons that mask early failures until the first hard freeze.

• Failed ignitors — hot-surface ignitors, common, replaceable, fix-it-now part on most calls
• Bad flame sensors — system runs briefly then shuts off, often just needs cleaning
• Gas valve failures — no gas to the burners, harder to diagnose, important to get right
• Cracked heat exchangers — safety issue. We test for it carefully and won't let you run a cracked unit
• Blower motor problems — squealing, weak airflow, complete failure
• Limit switch / pressure switch issues — the safety system doing its job, but stuck
• Control board failures — short cycling, no response, error codes
• Thermostat problems — surprising how often "broken furnace" is actually "broken thermostat"

Signs You Need Furnace Repair

• No heat or weak heat from the vents
• Furnace runs but blows cool air
• System cycles on and off rapidly (short cycling)
• Burning smell, gas smell, or burning electrical smell
• Unusual noises — banging, squealing, grinding
• Yellow burner flame instead of blue (combustion issue)
• Frequent thermostat adjustments to maintain temperature
• Furnace is running constantly but house never reaches setpoint

How a BakerHouse Furnace Repair Goes

• Tech arrives, listens to symptoms, looks at the system
• Full diagnostic — gas pressure, electrical, control logic, combustion, safety devices
• Combustion analysis to verify the unit is burning safely
• Clear options before any repairs begin — what's wrong, what it costs, what the alternatives are
• Most repairs done same-call with parts from the truck
• System tested through a full heat cycle before we leave

Safety Comes First

Furnace work isn't plumbing. Gas, combustion, and CO are real hazards if a repair is half-done. Our techs do combustion analysis on every repair call. If we find a cracked heat exchanger or unsafe combustion, we shut down the unit and tell you straight — no judgment, no upsell, just honest information.